Advertisement
Installing the Lift Cylinder
Important:
Use the cable tie to secure the lift-cylinder wire to the wire harness, away from sharp or
moving parts. Ensure that you allow enough slack in the wire harness for its full range of motion.
1.
Install the lift cylinder using a clevis pin and hairpin cotter.
2.
Connect the wire harness and secure it to the machine rail using the cable tie.
3.
Rotate the lift cylinder upward to a 45° angle, then use a block to support the lift cylinder.
4.
Press upward on the switch to extend the lift cylinder.
5.
Install the extended portion of the lift cylinder to the cargo bed using a clevis pin and hairpin cotter.
1x
2x
2x
8
1x
g037515
Advertisement
