Ducati CTR29 Instruction Manual page 23

ENGLISH
Terminal 3 - 230 Vac motor M1 power supply common
Terminal 4 - 230 Vac motor M1 power supply phase (opening)
Terminal 5 - 230 Vac motor M1 power supply phase (closure)
Note: connect the capacitor of the motor M1 between terminals 4 and 5
T J2
ERMINAL BOARD
Terminal 1 – Opening start push-button's normally open electric contact
Terminal 2 – Closing start push-button's normally open electric contact
Terminal 3 – Common terminal for all electric contacts of commands
Terminal 4 – Aerial input (signal)
Terminal 5 – Aerial input (shield)
C
ONNECTION OF THE DEVICES
230 Vac mains power supply cable and ground – Terminals 1 and 2 on J1
Warning: The cable's ground pole must be connected to a good ground reference in
the roller shutter's nearby area.
Motor 1 – Terminals 3, 4 and 5 on J1
Aerial – Terminals 4 and 5 on J2
NO Opening start push-button – Terminals 1 and 3 on J2
NO Closing start push-button – Terminals 2 and 3 on J2
Important: Before starting the roller shutter check all connections to the electronic
card. Check also the electric contacts' switching.
23