❸ Use; I Presentation Of The Regulation System; I Starting The Appliance; I Checks To Be Carried Out After Operating For A Few Moments - Zodiac Red Line 3 Installation And User Manual

❸ Use

3.1 I Presentation of the regulation system

Press and release
To confirm a value
To browse and adjust values
Description
"On/Off"
on
indicator light
Heating indicator
reg
lights

3.2 I Starting the appliance

• Open all valves (V1, V2 and V3) (see §"2.2 I Hydraulic connections"),
• Start the filter pump,
• Gradually close the by-pass valve (V1),
• Check that the water flow rate is between 5 and 30 m³/h. If the flow rate exceeds 30 m³/h, adjust valve 1
(V1) to reach 30 m³/h maximum,
• Check that there is no air in the circuit,
• Connect the regulation system to the power supply and turn it on,
• Adjust the set point temperature: to display and change the set point value, press
• The temperature is regulated by degrees.
• The set point can be adjusted to between 2°C and 40°C.
• To check that the filtration time is long enough:
- During the temperature rise phase, water circulation must be continuous (24 hours/day),
- To maintain the temperature throughout the season, run "automatic" circulation for at least
12 hours/day (the longer this time, the more the operating range of the appliance will suffice
for heating).

3.3 I Checks to be carried out after operating for a few moments

The heater must stop operating when:
• The temperature set point is lowered,
• The regulation system stops,
• Filtration stops.
8
Press and hold
"On/off"
To quickly scroll through the values
Steady Flashing
Appliance
switched /
on
On hold
Water flow rate too low (less than 5 m³/h)
Appliance
currently Filtration stopped
heating
Set point temperature greater than pool water
temperature (the indicator flashes for 15
seconds then is lit steadily).
Off
Inactive
Pool at
the desired
temperature
or .