Sharp UA-KIN50E Operation Manual page 18

BACK PANEL /
SENSORS
Remove the dust gently with a cleaning
tool such as a vacuum cleaner.
Sensors
Back Panel (Pre-Filter)
NOTE
• Do not apply excessive pressure when
scrubbing the Back Panel.
How to clean hard to remove dirt.
NOTE
Back Panel
1. Add a small amount
of kitchen detergent to
water and soak for about
10 minutes.
2. Rinse off the kitchen
detergent with clean
water.
3. Completely dry the filter
in a wellventilated area.
Sensor Filter
1. Remove the Back Panel.
2. Remove the Sensor
Filter.
3. If the Sensor Filter is very
dirty, wash it with water
and dry it thoroughly.
Sensors
Back Panel
Sensor Filter
EN-16
HEPA FILTER /
DEODORIZING FILTER
Remove the dust on the filters.
HEPA Filter
Clean only the tagged surface. Do not clean up the
opposite surface. The filter is fragile, so be careful
not to give too much pressure.
Tag
Deodorizing Filter
Both surfaces can be cleaned. The filter may be
broken if being too much pressure is applied on it,
so please handle it with care.
(Only UA-KIN40E)
NOTE
• Do not wash the filters. Do not expose to
sunlight. (Otherwise these filters may lose
efficacy.)
• Some odours absorbed by the filters will
break down over time, causing additional
odours. Depending on usage conditions,
and especially if the product is used in
environments significantly more severe than a
normal household, these odours may become
noticeable sooner than expected.
Replace the filter in those cases or if dust is
unable to be removed after maintenance.
(Only UA-KIN50E)