Advertisement
Hardware Setup
① Connect the LV8548MCSLDGEVB（Motor Driver Module）to the ONBB4AMGEVB（Motor Driver
Baseboard）. Insert the module into the baseboard, while being careful not to bend the header pins
② Connect the Arduino/Genuino Micro to the baseboard, as seen in the figure below. The USB connection
port should be labeled on the baseboard "USB" to dictate the orientation of the Arduino
③ Plug in the motor wires (Insulation between 5mm – 10mm) into the output terminals on the baseboard –
OUT_A/B/C/D. Refer to the table below for motor connectivity:
（Double check the motor wires, + and -, to ensure correct rotation direction）
④ Connect the Arduino to a PC using a USB cable.
⑤ Insert the AC Power adapter into the DC Jack on the baseboard. Be sure that a Center positive type
adapter is being used with an output voltage of 4-16V.
If using power supply cables, please connect the positive terminal to VCC and the negative terminal to
GND in the CN6 connector. The power supply terminals +/- at CN6 are polarity sensitive.(VCC=+,
GND=-)
How to use the GUI
LV8548MCSLDGEVB for Brush DC motor
OUT_A
OUT_B
OUT_C
OUT_D
③
CN5
⑤
www.onsemi.com
①
②
Motor1＋
Motor1－
Motor2＋
Motor2－
CN6
④
6
Advertisement
