Advertisement
Contents of the Kit
Hardware
• LV8548MCSLDGEVB：Motor driver module
• ONBB4AMGEVB：Baseboard
• Arduino Micro
• USB Cable (Micro B-A)
• USB Thumb Drive
• Flat-tip Screw Driver
• Brush DC Motor - RC-260RA-18130 (MABUCHI motor) 1pc
(Stepper motor 1pc)
Software(Included in USB Thumb Drive)
Software Setup
Please download
found on the provided USB flash drive to any
preferred directory.
(E.g. Libraries\Documents or Desktop)
API Library
Following process should be operated with the
Arduino Micro disconnected.
① Double click on the Arduino sketch
This will launch the Arduino IDE.
(Check the Appendix if the Arduino IDE is not
installed)
LV8548MCSLDGEVB for Brush DC motor
・・・Arduino IDE Installer
・・・Installer package in Japanese
・・・GUI Related Files
・・・GUI as well as .NET Framework4.6.1 Installer
・・・.NET Framework Related Files
・・・Stepper Motor Files
（Refer to Stepper Motor Manual）
.
www.onsemi.com
・・・API Library
・・・GUI – Arduino Firmware
・・・Instructions for operation and setup (This document)
・・・Appendix for supplementary material
The IDE will display the following message when
the LV8548_DC_Program.ino file is opened for the
first time. Click "OK" to continue.
This message will be displayed if the .ino file is not
inside of a folder with the same name. (E.g.
Sketch12345.ino must be in the Sketch12345
folder).
2
Advertisement
