Kubota LA463 Operator's Manual page 39

REINSTALLING THE LOADER
To avoid personal injury:
A When starting the engine and operating the
control valve, always sit in the operator's seat.
1. Slowly drive the tractor between the loader side
frames until the rear portion of both side frames
touches the main frames as shown.
(1) Side frame
(2) Main frame
2. Stop the engine.
3. Connect the four hoses with couplers to the nipples on
the control valve as indicated with color marks. Then
connect the protective caps and plugs to each other.
(1) Hoses
REINSTALLING THE LOADER
A Adjust the route of the hoses as shown.
(1) Hoses
4. Start the engine and run at idle.
5. Slowly move the hydraulic control lever to dump
position to lower the side frames into the main frames
and engage the bosses of the side frames to the guide
plates of the main frames. Then lift the weight off the
front wheels with the loader - do not lift the wheels off
the ground.
(1) Hydraulic control lever
A Do not attempt to lift the front wheels with the stands.
6. Stop the engine. Reinstall the mounting pins and
secure them with the spring pins.
7. Start the engine.
8. Raise the boom until the stands can be rotated.
9. Stop the engine.
27