PRE-OPERATION CHECK
LUBRICATION
Lubricate all grease fittings with SAE multipurpose
grease.
PRE-OPERATION CHECK
TRANSMISSION FLUID
Check the tractor transmission fluid level. Add fluid if
necessary. Refer to the tractor operator's manual for
instructions and proper fluid. Repeat this check after
purging air from the system. At that time, it will be
necessary to add transmission fluid.
A To check the tractor transmission fluid level, lower the
bucket to the ground and lower the 3 point hitch.
TREAD
1. Set front tread as follows.
2WD
L2800
1055mm
L3400
(41.5 in)
L3700SU
-
A Setting tread wider than recommended may cause
premature failure of front axle components due to
excessive stress.
2. For better stability, set the rear tread as follows
depending on the requirements of the work being
done.
L2800
L3400
L3700SU
Front Tread
4WD
Front axle is not
adjustable.
Rear Tread
1020mm (40.2 in.) or more
7