Chapter 7: Maintenance And Cleaning Of Your Machine; Water Inlet Filters - Kernau KFWD 8642 User Manual

CHAPTER 7: MAINTENANCE AND CLEANING OF YOUR
WARNING
Turn your mains power supply off and remove the plug from the socket before
carrying out maintenance and cleaning your machine.

WATER INLET FILTERS

Water inlet filters prevent dirt and foreign materials from entering your machine.
We recommend that these filters are cleaned when your machine is unable to
receive sufficient water, although your water supply is on and the tap is open. We
recommend that you clean your water inlet filters every 2 months.
• Unscrew the water inlet hose from the Washer Dryer.
• To remove the water inlet filter from the water inlet valve, use a pair of
long-nosed pliers to gently pull on the plastic bar in the filter.
• A second water inlet filter is located in the tap end of the water inlet hose.
To remove the second water inlet filter, use a pair of long-nosed pliers to
gently pull on the plastic bar in the filter.
• Clean the filter thoroughly with a soft brush and wash with soapy water
and rinse thoroughly. Re-insert the filter by gently pushing it back into
place.
CAUTION:
The water inlet filters can become clogged due to water quality or lack of
required maintenance and may break down. This may cause a water leak.
Any such breakdowns are out of the scope of the warranty.
MACHINE
Turn off the cold water supply before starting
maintenance and cleaning your machine.
CAUTION:
Do not use solvents, abrasive cleaners, glass cleaners or all-purpose cleaning
agents to clean your Washer Dryer. They may damage the plastic surfaces and
other components with the chemicals they contain.
EN 76