Water Inlet Connection - Kernau KFWD 8642 User Manual

WATER INLET CONNECTION

• Connect your Washer Dryer to your cold water supply only.
• Only use the water inlet hose supplied with your machine or one purchased through an authorised
dealer.
• A gasket is included in the hose packaging to prevent water leaks from connections. Fit this gasket to
the end of the water inlet hose that will be connected to the tap.
• Connect the angled end of the water inlet hose to the cold water inlet on the rear of the machine and
hand-tighten.
• Screw the other end of the water inlet hose onto a 3/4" water tap and hand-tighten.
• If in any doubt, consult a qualified plumber.
• Turn the cold water supply on and check for any leaks.
• Water flow with pressure of 0.1-1 Mpa will allow your machine to operate at optimum efficiency
(pressure of 0.1 Mpa means that more than 8 litres of water per minute will flow through a fully
opened tap).
• Ensure that the the hose is not trapped, kinked, twisted, folded or crushed.
• If your machine has a hot water inlet connection, the temperature of the hot water supply should not
be higher than 70°C.
NOTE:
Only use the water inlet hose supplied with your machine when making connections. Never use old, used or
damaged water inlet hoses.
3/4"
1
3
EN 58
2
4