Fitting/Removing The Comb Attachments - Silvercrest SHBS 500 D4 Operating Instructions Manual

Fitting/removing the comb attachments

WARNING! RISK OF INJURY!
► Never use the appliance with a defective or broken comb attach-
ment 0/q.
Missing teeth on the comb attachment 0/q could cause injuries.
► Switch off the appliance before fitting or removing a comb attach-
ment 0/q.
To fit a comb attachment 0/q push it onto the appliance below the
♦
shaving head 1. Make sure it slides into the guide rails 3 on the left
and right side of the appliance. Then push the comb attachment 0/q
along the guide rails 3 and slide it downwards (see fig. 2). While
doing so, keep the button on the rear of the comb attachment 0/q
pressed in.
SHBS 500 D4
1
2
Fig. 2
│
GB│MT
97 ■