Table of Contents
Advertisement
Available languages
Available languages
Turning the engine off
♦ Run the appliance for a short while without load before you switch it off so that the appliance can
"aftercool".
♦ Move the On/Off switch /36/ to the "OFF" position.
♦ Close the fuel tap /25/
Starting the appliance
♦ Switch on the water supply.
♦ Start the engine with the trigger /20/ open.
NOTE
► You can remove the jet pipe /16/ or the nozzle /4/ to make starting easier.
♦ Run the engine for 1 minute to warm it up. Setting operating pressure and flow rate
■ The pressure and flow rate are fixed on this appliance and cannot be changed.
Changing the nozzle
DANGER!
► Before changing the nozzle, switch off the appliance and pull the trigger/ 20/ to depressurise the
appliance.
♦ Remove the nozzle /4/.
♦ Fit the new nozzle /4/.
Use with a cleaning agent
WARNING!
► Switch off the appliance before making any adjustments or carrying out maintenance work.
WARNING!
► Unsuitable cleaning agents can damage the appliance and the object to be cleaned.
Use only recommended cleaning agents that are suitable for high-pressure cleaners.
This appliance is suitable for operation with the cleaning agents recommended by the manufacturer.
The use of other cleaning agents or chemicals can have a negative effect on the safety of the machine.
► The recommended cleaning agents are primarily those that are suitable for use with high-pressure
cleaners. These are available in DIY and car accessory stores.
♦ Hang the cleaning agent hose /11/ in a container with cleaning agent.
♦ Replace the high-pressure nozzle with low-pressure nozzle (black).
– 0° nozzle – red:
Extremely strong, precise jet. Cleans only a small area.
Do not use for cleaning wood!
– 15° nozzle – yellow:
Strong 15° jet for intensive cleaning of small surfaces.
Use only on surfaces and materials that can withstand high pressures.
– 25° nozzle – green:
25° jet for intensive cleaning of larger surfaces.
– 40° nozzle – white:
40° jet for cleaning large surfaces.
– Chemicals nozzle – black:
Low-pressure nozzle for the application of cleaning agents.
Recommended cleaning methods
– Dissolving dirt:
Spray the cleaning agent sparingly and leave to work for 1–5 minutes
but do not let it dry.
– Removing dirt:
Rinse off the dissolved dirt using a high-pressure jet.
After using with a cleaning agent
♦ Leave the appliance engine running and pull the trigger /20/ for at least 1 minute to rinse itself.
Interrupting operation
♦ Release the trigger /20/ on the hand spray gun /18/.
NOTE
► When you let go of the trigger /20/ of the hand spray gun /18/, the engine continues idling.
35
Advertisement
Table of Contents
