Adding Fuel; Water Connection - Raider RD-GHPC06 User Manual

NOTE
► The engine is equipped with an oil level sensor. The oil level sensor switches the engine off if the
oil level is too low and prevents a restart. If the engine cuts out although the oil level is correct, check
whether the petrol-powered high-pressure cleaner is standing straight.
Bleeding the oil tank
CAUTION!
► Before first use, the bleed valve on the oil tank needs to be replaced. On delivery, a black transport
oil plug /30/ is screwed in which has to be replaced by the supplied red oil plug /29/.
Engine
Observe the section "Safety instructions"!
■ Before use, read the manufacturer's operating instructions and pay close attention to the safety
instructions.
■ Checking the oil level of the engine. Do not use the appliance if the oil level has fallen below "MIN".
■ Add oil as required.
■ Fill the fuel tank /7/ with unleaded petrol. Do not use a 2-stroke mixture.

Adding fuel

DANGER! RISK OF FIRE AND EXPLOSION!
► Never refuel in confined spaces or when the engine is running
or still hot.
► Do not smoke while refuelling.
► Do not use any 2-stroke mixture.
► Do not refuel in the vicinity of open flames or sparks.
► Do not spill fuel – use a funnel.
► Wipe up any spilt fuel.
► After refuelling, close the fuel canister and the tank properly.
♦ Fill the fuel tank /7/ with unleaded petrol.
♦ Add fuel up to the red mark.

Water connection

See technical specifications for the connection data.
■ Connect the supply hose (minimum length 7.5 m, minimum diameter 3/4") to the water connection
on the appliance and to the water supply (e.g. tap).
■ Turn on the water supply.
NOTE
► The water supply hose is not included in the delivery.
Drawing water out of a container
DANGER!
► Never prime with liquids containing solvents such as paint thinners, petrol or oil. Atomised spray
from solvent is highly flammable, explosive and toxic.
♦ Connect the suction hose /33/ (diameter at least 3/4") with the filter /31/(accessories) to the water
connection /38/.
Self-priming from open tanks/containers and natural water sources
Use the self-priming equipment supplied.
– Intake filter /31/
– 3 m reinforced suction hose /33/
With this accessory the appliance can draw water to max. 1 m above the water surface. This can take
up to 1 minute.
♦ Immerse the 3 m suction hose /33/ completely underwater to get the air out.
♦ Connect the suction hose /33/ to the appliance and ensure that the intake filter /31/ remains
underwater.
♦ Run the appliance without the hand spray gun /18/ attached until water flows evenly out of the high-
pressure hose /1/. If no water flows out after 1 minute, switch the appliance off and check the appliance.
Once the water flows, switch off the appliance and attach the hand spray gun /18/ and the jet pipe /16/ so
you can work.
33