Raider RD-GHPC06 User Manual page 32

32 www.raider.bg
while unpacking, and during assembly, storage as well as during operation, inspection, maintenance
and when at a standstill.
Fitting the handle
♦ Insert the handle A on the base frame of the device. Press the two pushbuttons on the base frame
and push the handle A completely until it clicks into place.
Fitting the hose holder
♦ Fit the hose holder /3/ onto the handle A by aligning the holes in the two components.
♦ Fix the hose holder /3/ in place on the handle A with two screws /49, 50/ and two nuts /54/ (on the
right side, see fold-out page).
Fitting the upper spray gun holder on the handle
♦ Use two screws /45/, two washers /48/, and two nuts /54/, to fit the upper spray gun holder /19/ onto
the handle A.
Fitting the lower spray gun holder on the tubular frame
♦ Use two screws attach the lower spray gun holder /13/ onto the tubular frame /8/.
Fitting the wheels
♦ Push a washer /53/ onto the axle /42/.
♦ Push the axle /42/ from outside through the wheel /14/ and place another washer /53/ on the axle
/42/.
♦ Now guide the axle with the wheel from the outside into the tubular frame /8/. Place another washer
/53/ onto the axle /42/ and secure it in place with the R-clip /44/.
♦ Repeat the process on the opposite side.
Fitting the rubber feet
♦ Attach the rubber feet /12/ with the screw /46/, washer /52/ and nuts /51/ onto the tubular frame /8/.
Use the supplied open end wrench /55/ and allen key /57/ for assistance.
Fitting the hand spray gun, the jet pipe and the nozzle
DANGER!
► Risk of injury! Appliance, supply pipes, high-pressure hose and connections must be in perfect
working order. If the equipment is not in perfect working order, the appliance may no longer be used.
♦ Connect the jet pipe /16/ to the hand spray gun /18/.
♦ Tighten the screws of the jet pipe /16/ by hand.
♦ Fit the nozzle /4/ onto the jet pipe /16/. Ensure that it clicks into place
correctly.
♦ Fit the high-pressure hose /1/ onto the hand spray gun /18/.
Operation
Checking the oil level of the engine
■ Check the oil level before each use.
■ Do not use the appliance if there is no oil visible on the dipstick /34/.
■ Add oil as required. Use only engine oil (15W40).
♦ Place the appliance on a flat, level surface and remove all dirt from around the oil inlet/dipstick /34/.
♦ Use the dipstick to measure the oil level.
Unscrew the dipstick /34/ and wipe it clean with a cloth. Put the dipstick back into the oil inlet without
screwing it in. Pull the dipstick /34/ back out and check the oil level.
♦ Check that the oil level is somewhere between the minimum and maximum
levels (marked as L for low and H for high on the dipstick /34/).
To fill up the oil, take the supplied funnel /43/ and pour the oil slowly into the oil inlet . Do not overfill!
♦ Wait a minute until the oil has settled before measuring the oil level
again as described above.
♦ Screw the dipstick back into the oil inlet. /34/
CAUTION!
► Do not overfill the oil. A too high oil level can cause engine damage.
The maximum fill level for the tank is 0.6 litres.