Begin To Measure, Taking And Storing A Reading - Hyundai BPM 850 Instruction Manual

3) Before applying the arm cuff, remove any tight clothes, watches or jewellery from your arm.
4) Rest your arm on the table so that it is loosely stretched and the cuff is at your heart level or
lie on a bed and place your arm alongside of your body (fig. 3). The arm must be at ease.
Do not speak while taking the readings.
5) The arm cuff must be at the heart level the whole time otherwise the readings will not be accurate.
6) Bear in mind that blood pressure changes during the day. Try to measure your blood pres-
sure several times during the day so that you can better understand your body and its
response to various situations (after physical activity, while working, after meals ...). If you
wish to achieve comparable results, always take the measurements at the same time of the
day and under the same conditions.
7) Do not give weight to one reading only. At least two readings should be taken and there
should be an interval of about 5 minutes between them. More readings taken after a longer
period of time will give you better information about your blood pressure.
8) Sensitive people might experience certain discomfort while taking the measurements.
9) If the pressure in the cuff is too high, if you do not feel well or if you start feeling unwell all of
a sudden, please press the key ON/OFF for immediate and fast deflation (deflating of air).
10) If the device is used in temperatures or moisture outside the limits specified in the section
on TECHNICAL SPECIFICATIONS, the readings will not be accurate.
BEGIN TO MEASURE
1) Press the ON/OFF key.
2) Once all the basic information has been displayed, the arm cuff will start to inflate, the
symbol (inflation) will be shown on display.
3) The air pressure in the arm cuff will slowly start to deflate. Once a tendency towards high
pressure has been recognised the arm cuff will inflate a bit more and the pressure in the arm
cuff will increase. As soon as the pulse is recognizable, the
the monitor.
4) The measurement results of systolic pressure, diastolic pressure and pulse rate (pulse) will
be displayed on the monitor.
5) You can finish the measurement at any time by pressing the ON/OFF key.
6) If an "E" symbol appears on the monitor, the measurements were not properly taken. Please
follow the TROUBLESHOOTING instructions and repeat the measuring.
7) The readings will be automatically stored into the memory of readings of the person who is
currently being measured.
ENG - 45
symbol will be displayed on
ENG