Table of Contents
Advertisement
installation
Square Door Installation - F2452
SQUARE DOOR INSTALLATION - F2452
When assembling the stove with pedestal or legs - install the tool holder
for the door handle storage.
Unfasten the bottom screw on the back left side of the unit and attach the
tool holder as shown below.
DOOR INSTALL
1. Place door onto the two hinge pins on the body of the stove.
2. Place hinge pin caps to the top of both door hinges.
919-402a
|
10
F2452 Regency Freestanding Wood Fire
Tool Holder
Screw
3. Remove the nuts, washers, cam and spacer from the handle assembly
4. Slide the handle shaft into the hole in the door with the end of the
handle facing down.
5. Slide the spacer, washers, cam, then another washer, the 2 nuts onto
the handle shaft as shown. Tighten the nuts but do not overtighten so
the handle can move freely.
LATCH ADJUSTMENT
Each door handle may require 4 washers between the cam and door
spacer. (2 washers are included as spares if required)
The door latch may require adjustment as the door gasket material
compresses over time. Removal of 1 or 2 washers will allow the latch to
move closer to the door frame, creating a tighter seal.
Remove washer(s) from the door handle assembly as required.
The cool to touch door handle is designed to be inserted from the bottom
up and slide off when not held in place. Once in position, the door can be
opened. After use, store the door handle on the storage hook located on
the left side of the appliance.
Handle
WARNING: FAILURE TO USE
REMOVABLE HANDLE AS PER INSTRUCTIONS MAY
CAUSE SERIOUS BURNS.
F2452
Tool
Holder
03/10/21
Advertisement
Table of Contents
