Electronic Button Hole Balance - Freesia 425/415 -Lisa -Angelica -Victoria - Husqvarna VIKING 350 Service Manual

Key 7 Is used for checking the:
- Pre-setting of the step motor of the needle.
The needle height. Setting nr 8.
- Pre-setting of the feeding step motor.
Feed dog below the stitch plate. Setting nr. 17
Key 8 Check that the arm shaft sensor (stop right function) works.
The latter looks after when the step motors have to be reset,
it reads the speed and the stop right functions.
The function is correct if numbers 0-3 are shown in the right
part of the display, while the handwheel is turned around slowly.
Key 17 Is used when fine-adjusting the stitch length balance.
Setting nr. 18
Electronic button hole balance
Freesia 425/415,Angelica. Victoria
It is not possible to do any electronic button hole balance on the Freesia 425/415,the Angelica.
and the Victoria
Electronic button hole balance
Lisa
Electronic button hole balance should NOT be carried out on a Lisa.
If a electronic buttonhole balance is made - on a Lisa - it will influence the stich leghts balance
on all stiches. The setting of the electronic button hole balance MUST BE -3
Check of the setting of the Electronic button hole balance
Enter Electronic button hole balance menu - by choose any buttonhole and then push the
arrows
In this menu the setting MUST BE -3. This value should NOT be re-set in any way.
NOTE! If the PC board is changed on a Lisa the setting must to be set to -3 before any
stich lenght balance is set.
34
104 72 57-26