Setting The Hook In Relation To The Feedingeccentric (After Feeding). Version 1 - One Pin - Husqvarna VIKING 350 Service Manual

2. Setting the hook in relation to the feeding
eccentric (after feeding). Version 1 - one pin
Check
1. The needle shall be in its centre position, straight stitching.
2. Set the tip of hook (A) so is centred behind the needle, the tap of the worm gear
should now be positioned according to fig. 2
Alt. Check
1. When the two taps of the worm gear are positioned according to fig. 2 the tip (A) of the hook
should point straight backwards.
Adjustment
1. Loosen screw (B). Remove the hook and set it into its correct position.
Note! If none or only one pin is found please clean the worm gaer and look for a breaking
mark.
8
104 72 57-26