Wiring; Voltage Selection Adjustments; Line Voltage Plug And Receptacles (Shown With Covers Removed) For Horizontal Design - Eaton Cutler-Hammer ATVSKDA30300XSU Instructions Manual

Page 20
!
DO NOT RUN POWER CABLES BEHIND OR TO THE
LEFT OF THE POWER PANEL. THE CABLES
SHOULD BE RUN IN THE GUTTER SPACE PROVID-
ED AS SHOWN IN FIGURE 4-1. RUNNING THE
CABLES IN PLACES NOT RECOMMENDED COULD
INTERFERE WITH THE PROPER OPERATION OF
THE TRANSFER SWITCH.
NOTICE
Remember to re-attach the solid steel power panel
deadfront shield to the ratchet assembly on the ver-
tical design after completing any of the procedures
described in this section.

4.6 WIRING

!
POWER CONDUCTORS AND CONTROL WIRING
MAY HAVE VOLTAGE PRESENT THAT CAN CAUSE
SEVERE PERSONAL INJURY OR DEATH. DE-ENER-
GIZE ALL POWER OR CONTROL CIRCUIT CONDUC-
TORS BEFORE BEGINNING TO PERFORM ANY
WIRING ACTIVITY TO OR WITHIN THE TRANSFER
SWITCH EQUIPMENT.
Power sources, load conductors and control wiring
should be connected to locations as indicated in the
Customer Wiring Booklet supplied with the transfer
switch equipment.
!
DO NOT RUN POWER CABLES BEHIND OR TO THE
LEFT OF THE POWER PANEL. THE CABLES
SHOULD BE RUN IN THE GUTTER SPACE PROVID-
ED AS SHOWN IN FIGURE 4-1. RUNNING THE
CABLES IN PLACES NOT RECOMMENDED COULD
INTERFERE WITH THE PROPER OPERATION OF
THE TRANSFER SWITCH.
CAUTION
CAUTION
CAUTION
!
CHECK THE TRANSFER SWITCH EQUIPMENT
NAMEPLATE FOR RATED VOLTAGE. IT SHOULD
BE THE SAME AS THE NORMAL AND EMERGENCY
LINE VOLTAGES. OPERATING THE EQUIPMENT ON
IMPROPER VOLTAGE CAN CAUSE EQUIPMENT
DAMAGE.
Once the transfer switch equipment has been installed
and wired, perform initial mechanical and electrical pro-
cedures as outlined in Section 6 to verify that the equip-
ment is installed and operating properly.
NOTICE
Remember to re-attach the solid steel power panel
deadfront shield to the ratchet assembly on the ver-
tical design after completing any of the procedures
described in this section.

4.7 VOLTAGE SELECTION ADJUSTMENTS

Certain devices, such as the Voltage Selection Panel,
sensing relays and timers, need to be set and/or cali-
brated prior to placing the transfer switch equipment into
service. Adjustments for logic devices are described in
the separate instructional document dedicated to the
specific logic being used. Voltage selection adjustments
are described here.
Figure 4-6 Line Voltage Plug and Receptacles (shown
with covers removed) for Horizontal Design
I.B. ATS-V003
CAUTION
Effective 6/98