Raider RD-HPC01 User Manual page 20

20 www.raider.bg
6.1. Clean the water filter once a month or more frequently depending on use. See also
paragraph 3.10.
6.2. When obstruction of the nozzle is obtained very high pressure. Therefore, it is
immediately necessary cleaning. IMPORTANT: Instrument cleaning nozzle (5) should be
used only when high pressure cleaner is off!
6.3. Vent should always be clean and free.
6.4. If necessary, repair your high pressure cleaner power and is best carried out only
by qualified specialists in workshops RAIDER, which used only original spare parts. Thus
ensuring their safe operation.
7. Removal of possible malfunctions.
The table below shows signs of defects and how you can help if your power fails to operate
normally. If you can not find and fix the problem by following the instructions in the table,
contact the authorized service of Rider. Warning: Before you begin troubleshooting, high
pressure cleaner and stop it from the supply network.
Problems
Machine is not
starting
The engine stops
Working pressure is
too high
Pulsing pressure
The engine is
working but there is
no pressure
If necessary, repair your machine is best carried out only by qualified specialists in
workshops RAIDER, which used only original spare parts. Thus ensuring their safe operation.
11. Environmental protection.
Cause
the plug is not inserted in
the socket.
the socket is broken.
The safety switch has been
activated
The extension cable is
damaged
The automated protection
has bee activated
The nozzle is partly stuck
There is air in the ump or
the hose..
Watter feeding is not good.
Water filter (6а) need
cleaning.
The water hose is twisted
or folded.
There is no water feeding.
The filter (6а) need
cleaning.
What to do
Insert the plug in the socket
Use another socket
After checking the reason for activation of
the safety swith, replace it (ot switch it on)
Replace it.
Wait a few minutes untill engine cools
Check and clean it - See p. 6.2.
Remove the extra air - see p. 4.7 и 4.8.
Ensure that the parametserof the water
network are appropriate to what is shown in
p. 3.10.
Check and clean the water filter. See p.
3.10. and figure (А) and (F).
Check and fix it
Turn the water supply on.
Check and clean the water filter. See p.
3.10. and figure (А) and (F).