The Washing And Drying Results Are Not Satisfactory - Zanussi ZDLN5521 User Manual

Hide thumbs Also See for ZDLN5521:
Table of Contents

Advertisement

Available languages

Available languages

WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.

THE WASHING AND DRYING RESULTS ARE NOT SATISFACTORY

Problem
Poor washing results.
Poor drying results.
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The interior of the appliance is
wet.
Unusual foam during washing.
Traces of rust on cutlery.
20
Possible cause and solution
Refer to "Daily use", "Hints and tips" and the basket load-
ing leaflet.
Use more intensive washing programme.
Activate the Extra Power option to improve the washing re-
sults of a selected programme.
Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
Tableware was left for too long inside the closed appliance.
Activate AirDry to set the automatic opening of the door and
to improve the drying performance.
There is no rinse aid or the dosage of rinse aid is not suffi-
cient. Fill the rinse aid dispenser or set the level of rinse aid
to a higher level.
The quality of the rinse aid can be the cause.
We recommend to use rinse aid always, even in combination
with multi-tablets.
Plastic items may need to be towel dried.
The programme does not have the drying phase. Refer to
"Programmes overview".
The released quantity of rinse aid is too high. Adjust the rinse
aid level to a lower level.
The quantity of detergent is too high.
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid level to a higher level.
The quality of the rinse aid can be the cause.
This is not a defect of the appliance. Humid air condensates
on the appliance walls.
Use the detergent designed specifically for dishwashers.
There is a leak in the rinse aid dispenser. Contact an Author-
ised Service Centre.
There is too much salt in the water used for washing. Refer to
"The water softener".
Silver and stainless steel cutlery were placed together. Do
not put silver and stainless steel items close together.

Advertisement

Table of Contents
loading

Table of Contents