1. Set the replacement Moisture Separator into the center bore of the Oil Reservoir with the flange centered in the machined recess (FIG 45).
2. Replace the Head Plate and hold in place by loosely hand threading in 2 of the 8 Head Plate bolts to allow some movement of the Head Plate and avoid
cross-threading the line fittings.
3. Reconnect the oil outflow line at the inlet to the Scroll. NOTE: Use caution not to cross-thread the compression nut on the stationary line fitting.
4. Reconnect the oil line compression fitting at the 90° elbow attached to the Head. NOTE: Use caution not to cross-thread the compression nut on the
stationary line fitting.
5. Thread in the remaining 6 Head Plate Bolts.
6. Torque Head Plate bolts initially to 30 lb-ft [40.7Nm] then to 62 lb-ft [84.3Nm]. NOTE: Follow Head Plate torquing sequence as shown in (FIG 46).
7. Replace Check Valve housing (FIG 47).
8. Reconnect DIN Connector to the Pressure Sensor and secure by threading on retaining ferrule (FIG 47).
9. Refill with 74 oz. [2.2 liter] of Eastwood #31718 Scroll Compressor Oil.
10. Restore power to Compressor. Depress the "START" Button
11. Press the "OFF" Button
FIG. 45
To order parts and supplies: 800.343.9353 >> eastwood.com