Table of Contents
Advertisement
Condensing Units
Check the selected installation location to ensure that racks, braces, flooring, foundations, etc. are adequate to
•
support the condensing unit weight.
The installation location is clean, dry, and level.
•
Locate away from corrosive and noise sensitive atmospheres.
•
Use the condensing unit skid and base when moving the unit. Do not remove unit from skid until the unit is moved to
•
the mounting location.
Mount the condensing unit base to pads or structural rails using properly sized bolts through the unit base. Center of
•
condensing unit needs to be properly supported.
•
Locate where there is a sufficient and unrestricted supply of clean ambient air.
•
Locate where this is adequate space for the removal of the heated discharged air from the condensing unit area.
•
Do not position multiple units so that discharge air from one unit is blowing into the condenser inlet air of the other
unit.
•
All sides of the unit should be positioned a minimum distance equal to the total width of the condensing unit away
from any other unit, wall, or obstruction.
•
Check the selected installation location to ensure that racks, braces, flooring, foundations, etc. are adequate to
support the condensing unit weight.
•
The installation location is clean, dry, and level.
•
Locate away from corrosive and noise sensitive atmospheres.
•
Use the condensing unit skid and base when moving the unit. Do not remove unit from skid until the unit is moved to
the mounting location.
•
Mount the condensing unit base to pads or structural rails using properly sized bolts through the unit base. Center of
condensing unit needs to be properly supported.
Section 2
Installation
5
Advertisement
Table of Contents
