Table of Contents
Advertisement
www.ti.com
3. Connect a micro-USB cable to the MSP430 LaunchPad and the PC.
4. Click on the Build Project icon or "Ctrl" + B to ensure the project builds successfully. Accept any updates if
needed from the Console.
5. Click on Debug Project to set up a debug session and press the Play button to run the code.
6. Stop the debug session, close Code Composer Studio, disconnect the SPI-by-Wire jumpers, and unplug the
micro-USB cable from the MSP430 LaunchPad.
Table 7-1. SPY-BI-Wire Connections Needed to Program MSP430FR2355
™
MSP430 LaunchPad
(eZ-FET Debug Probe Side) (J101)
SBWTDIO
SBWTCK
Figure 7-2. MSP430 LaunchPad
SLLU340 – AUGUST 2021
Submit Document Feedback
GND
3V3
™
eZ-FET Probe Connected to MCT8316AEVM
Copyright © 2021 Texas Instruments Incorporated
MSP430FR2355 Interface Firmware
MCT8316AEVM 4-pin SPI-by-Wire Header (J4)
GND
3.3V
SBWTDIO
SBWTCK
MCT8316AEVM Evaluation Module
15
Advertisement
Table of Contents
