T-Fal NutriCook User Manual page 10

EN
Fitting and removing the timer
• To fit the Smart Timer
part, then clip down the front part.
• To remove the Smart Timer
Cooking always takes place in two phases:
• The duration of the first pressure phase is directly linked
to the chosen recipe or the kind of ingredients to be
cooked, and this is the time you need to programme on
the Smart Timer
• The second soft cooking phase is pre-programmed into
the Smart Timer
have to do is follow the guide below...
• You can switch the Smart Timer
pressing simultaneously on both buttons.
• During cooking you can change the cooking time only
if the Smart Timer
During the soft steam phase, you cannot modify the
cooking time.
put in the
ingredients
programme
the cooking time
NutriCook heats up
11
• To make it easier to use your NutriCook, the Smart Timer
is there to help and guide you through your recipes.
®
(C) Fig. 7, first insert the rear
®
(C), press the tab and lift it.
®
using the – and + buttons.
®
and follows on automatically. All you
®
®
is positionned on the NutriCook.
close
NutriCook
®
turn on the heat,
to full power
turn down the heat so
there is a constant,
steady release of steam.
off at any time by
select a
programme
0
MAXI
0 MAXI
Rear part
Front part
Tab
Never open your
NutriCook before the
end of the soft cooking
phase, as you could
stop the cooking
process before the
ingredients are fully
cooked. Refer to the
"End of cooking"
heading.
Heat source
at max.
Programmed
time set
Heat source
at reduced
Cooking
time
counts down
®