Table of Contents
Advertisement
1080 North Crooks Road
Clawson, MI 48017-1097
Phone: 248-435-0700
Fax: 248-435-8120
www.ameteksensortech.com • www.ametek.com
Preface
This manual is divided into three parts. Part 1 provides the hardware overview for the 955QD Linear
Displacement Transducers (LDT). Part 2 provides instructions for installing the LDT's to a mounting bracket.
Part 3 provides an overview and wiring instructions for the 955QD Quadrature Output LDT. To further assist
you, a glossary is provided at the back of the manual.
!
Disconnect Power Before Servicing. The Gemco 955QD LDT Contains No
Serviceable Components. Consult Factory for Repair or Replacement.
Copyright 2001 by AMETEK Automation & Process Technologies
AMETEK Automation & Process Technologies has checked the accuaracy of this manual at the time it was
approved for printing. However, this manual may not provide all possible ways of installing and maintaining
the LDT. Any errors found in this manual or additional possibilities to the installation and maintenance of
the LDT will be added in subsequent editions. Any comments you may have for the improvement of this
manual are welcomed.
AMETEK reserves the right to revise and redistribute the entire contents or selected pages of this manual.
All rights to the contents of this manual are reserved by AMETEK. The Brik is a registered trademark
of AMETEK.
All Rights Reserved -- Made in the USA
Version 1.0
Advertisement
Table of Contents
