Wheel Removal; Front Wheel Removal - Honda CRF110F 2019 Owner's Manual

WHEEL REMOVAL

Refer to the Safety Precautions on page 58.

Front Wheel Removal

1. Raise the front wheel off the ground by
placing a support block under the engine.
2. Loosen the cable guide bolt (1).
3. Disconnect the front brake cable (2)
from the brake arm (3).
4. Remove the front axle nut (4) and front
axle. The front wheel can now be
removed.
(1)
(2)
(1) Cable guide bolt
(2) Front brake cable
(3) Brake arm
(2) (6)
(3)
(4) Front axle nut
(5) Lug
(6) Slot
Installation:
1. Reverse the removal procedure. Make
sure that the lug (5) on the fork leg is
located in the slot (6) in the brake panel.
Be sure to tighten the front axle nut to:
59 N·m (6.0 kgf·m, 44 lbf·ft)
2. Check front brake adjustment.
3. After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
( )
If a torque wrench is not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
(4)
85