Honda ANC125 2019 Owner's Manual page 74

Engine Oil Changing Engine Oil, Cleaning Strainer Screen
u
Place your scooter on its centre stand on
3.
a firm, level surface.
Place a drain pan under the drain bolt
4.
and oil plug.
Remove the oil fill cap/dipstick, drain bolt
5.
and sealing washer to drain the oil.
Remove the oil plug, O-ring, spring and
6.
oil strainer screen and let the remaining
oil drain out.
Discard the oil at an approved
u
recycling centre.
Clean the oil strainer screen.
7.
Check that the oil strainer screen and
8.
sealing rubber are in good condition.
Replace the O-ring and apply a thin coat
9.
of engine oil to the new O-ring before
installing it.
Install the oil strainer screen, spring and
10.
oil plug and tighten.
Torque: 20 N·m (2.0 kgf·m, 15 lbf·ft)
70
Sealing washer
Spring
Oil strainer screen
Drain bolt
Oil plug
O-ring