Table of Contents
Advertisement
1 General information
The language of the original operating instructions is
English. All other languages of these instructions are
translations of the original operating instructions.
These installation and operating instructions are an
integral part of the product. They must be kept readily
available at the place where the product is installed.
Strict adherence to these instructions is a precondition
for the proper use and correct operation of the product.
These installation and operating instructions correspond
to the relevant version of the product and the underlying
safety standards valid at the time of going to print.
Supplied
pump
will operate trouble free and
satisfactorily on the condition that, it is installed with
due care and maintained properly.
If operating parameters deviate from the specified
parameters as on the "Nameplate", please contact
manufacturer."
The manufacturer reserves the right to make technical
modifications to the device or individual components.
The illustrations used may differ from the original and
are intended as an example representation of the device.
2 Safety
These operating instructions contain basic information
which must be adhered to during installation and
operation. For this reason, these operating instructions
must, without fail, be read by the service technician and
the responsible operator before installation and
commissioning. The machine operator list must be filled
out completely. By signing this list, all persons working
on or with the product confirms that they have received,
read and understood this operating & maintenance
manual.
It is not only the general safety instructions listed under
the main point "safety" that must be adhered to but also
the special safety instructions with danger symbols
included under the following main points.
2.1 Designation of information in the
operating instructions
Symbols:
General danger symbol
Danger due to electrical voltage
NOTE: ...
Signal words: DANGER!
Acutely dangerous situation.
Non-observance results in death or the most
serious of injuries.
Installation and operating instructions WILO Mather and Platt –MISO / PISO Pumps
Warning!
The user can suffer (serious) injuries. "Warning" implies
that (serious) injury to persons is probable if this
information is disregarded.
CAUTION!
There is a risk of damaging the pump/installation.
"Caution" implies that damage to the product is likely if
the information is disregarded.
NOTE:
Useful information on using the product. It also draws
attention to possible problems.
2.2 Personnel qualifications
The installation personnel must have the appropriate
qualification for this work.
2.3 Danger in event of non-observance of the safety
instructions
Non-observance of the safety instructions can result in risk
of injury to persons and damage to product/installation.
Non-observance of the safety instructions can result in the
loss of any claims to damages.
In detail, non-observance can, for example, result in the
following risks:
• Failure of important product/installation functions
• Failure of required maintenance and repair procedures
• Danger to persons from electrical, mechanical and
bacteriological influences
• Property damage
• WILO Mather and Platt does not accept any liability for
damage, failures or losses arising due to improper
installations, maintenance, repair works, modifications
without our consultation and non-observance of safety
instructions mentioned in this IOM.
2.4 Safety consciousness on the job
The safety instructions included in these installation and
operating instructions, the existing national regulations for
accident prevention together with any internal working,
operating and safety regulations of the operator are to be
complied with.
2.5 Safety instructions for the operator
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
• If hot or cold components on the product/the unit lead to
hazards, local measures must be taken to guard them
against touching.
• Guards protecting against touching moving components
(such as the coupling) must be removed whilst the product
is in operation.
• Leakages (e.g. from the shaft seals) of hazardous fluids
(which are explosive, toxic or hot) must be led away so that
no danger to persons or to the environment arises. National
statutory provisions are to be compiled with.
• Highly flammable materials are always to be kept at a safe
distance from the product.
8
Hide quick links:
Advertisement
Table of Contents
