Electrolux EGD6576NOK User Manual page 20

20 www.electrolux.com
3. Remove the knob.
4. With a thin screwdriver, adjust the
bypass screw position (A).
A
5. If you change:
• from natural gas G20 20 mbar to
• from natural gas G20 20 mbar to
• from liquid gas to natural gas G20
• from natural gas G20 20 mbar to
• from liquid gas to natural gas G20
• from natural gas G20 13 mbar
8.6 Electrical connection
• Make sure that the rated voltage and
type of power on the rating plate agree
with the voltage and the power of the
local power supply.
• This appliance is supplied with a mains
cable. It has to be supplied with a
correct plug which can hold the load
liquid gas, fully tighten the bypass
screw in.
natural gas G20 13 mbar (only for
Russia), fully tighten the bypass
screw in.
20 mbar, undo the bypass screw
approximately 1/4 of a turn.
natural gas G20 13 mbar (only for
Russia), undo the bypass screw
approximately 1/4 of a turn.
13 mbar (only for Russia), undo the
bypass screw approximately 1/2 of
a turn.
(only for Russia) to natural gas G20
20 mbar, tighten the bypass screw
approximately 1/4 of a turn.
WARNING!
Make sure the flame does not
go out when you quickly turn
the knob from the maximum
position to the minimum
position.
that the rating plate rates. Make sure
that you install the plug in a correct
socket.
• Always use a correctly installed
shockproof socket.
• Make sure that there is an access to
the mains plug after the installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• There is a risk of fire when the
appliance is in connection with an
extension cable, an adapter or a
multiple connection. Make sure that the
ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
Make sure that you connect
the blue neutral cable to the
terminal with a letter "N" on it.
Connect the brown (or black)
phase cable to the terminal
which has a letter "L". Keep
the phase cable connected at
all times.
8.7 Connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make
sure that the cable section is applicable to
the voltage and the working temperature.
The yellow / green earth wire must be
approximately 2 cm longer than the brown
(or black) phase wire.
8.8 Attaching the seal
1. Clean the worktop around the cut out
area.
2. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
4. Push the two ends of seal stripe
together.