Download Print this page

Toyota Paseo 1998 Manual page 80

Advertisement

WWW.MANUALS.WS
Your automatic transmission has a shift
lock system to minimize the possibility of
incorrect operation. This means you can
only shift out of "P" position when the
brake pedal is depressed (with the ignition
switch in "ON" position and the lock re-
lease button depressed).
(a)
Normal driving
1. Start the engine as instructed in "How
to start the engine" in Part 3. The
transmission must be in "P" or "N".
2. With your foot holding down the brake
pedal, shift the selector lever to "D".
In "D" position, the automatic transmission
system will select the most suitable gear
for running conditions such as normal
cruising, hill climbing, hard towing, etc.
Always turn the overdrive switch on for
better fuel economy and quieter driving. If
the engine coolant temperature is low, the
transmission will not shift into the over-
drive gear even with the overdrive switch
on.
CAUTION
Never put your foot on the accelera-
tor pedal while shifting.
80
WWW.MANUALS.WS
3. Release the parking brake and brake
pedal. Depress the accelerator pedal
slowly for smooth starting.
(b)
Using engine braking
To use engine braking, you can downshift
the transmission as follows:
"
Turn off the overdrive switch. The "O/D
OFF" indicator light will come on and
the transmission will downshift to the
third gear.
"
Shift into the "2" position when the
vehicle speed is lower than 111 km/h
(69 mph). The transmission will down-
shift to the second gear and more en-
gine braking will be obtained.
"
Shift into the "L" position when the
vehicle speed is lower than 44 km/h
(27 mph). The transmission will down-
shift to the first gear and maximum
engine braking will be applied.
CAUTION
Be careful when downshifting on a
slippery
surface.
Abrupt
shifting
could cause the vehicle to spin or
skid.
(c) Using the "2" and "L" positions
The "2" and "L" positions are used for
strong engine braking as described pre-
viously.
With the selector lever in "2" or "L", you
can start the vehicle in motion as with the
lever in "D".
With the selector lever in "2", the vehicle
will start in the first gear and automatical-
ly shift to the second gear.
With the selector lever in "L", the trans-
mission is engaged in the first gear.
NOTICE
z Be careful not to overrev the en-
gine. Watch the tachometer to keep
engine rpm from going into the red
zone. The approximate maximum al-
lowable speed for each position is
given below for your reference:
"2"
. . . . . . . . . . .
96 km/h (59 mph)
"L"
. . . . . . . . . . .
53 km/h (32 mph)

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Tercel 1998