Booting The Switch; Component Leds - Nokia Alcatel-Lucent OmniSwitch 6360 Hardware User's Manual

Booting the Switch

Booting the Switch
Now that you have installed the switch components and connected network and management cables, you can
boot the switch. To boot the switch, plug all power supply cords into easily-accessible, properly grounded
power outlets. (Do not use extension cords.) The switch will power on and boot automatically.
Note. If you have more than one power supply installed, be sure to plug in each power supply in rapid
succession, (i.e., within a few seconds of each other). This ensures that there will be adequate power for all
components throughout the boot process.

Component LEDs

During the boot process, component LEDs will flash and change color, indicating different stages of the boot
For complete information on LED states, refer to
Once the switch has completely booted and you have accessed your computer's terminal emulation software
via the console port, you are ready to log in to the switch's Command Line Interface (CLI) and configure basic
information. Continue to
page 2-6
"Chassis Status LEDs" on page
"Your First Login Session" on page
3-20.
2-7.
OmniSwitch 6360 Hardware Users Guide
Getting Started
April 2021