Table of Contents
Advertisement
D. Wall Switch Control Assembly
►
The Lanai series outdoor gas appliance is supplied
with a wall switch control panel. See Figure 5.7.
Figure 5.7. Wall Control Switch Assembly
NOTE: Supplied wire allows for the control
assembly to be mounted up to 14 feet from
the appliance.
be installed on the left or right side of the
appliance for wall switch control wire routing.
•
The control box can be rerouted on the right or
left side of the unit.
•
Locate controls by lifting engine and using
support legs. To access Intellifire control
module and LED control module, lift control
box cover off of controls.
•
The rocker switch wire (Black/white) must
be plugged into the two brown wires on the
control wiring harness. There is no incorrect
connection for these two wires. Shown in
wiring diagram (Figure 5.6.)
•
The yellow cable for the two LED buttons plugs
into the LED module (Yellow control module)
located under the control cover which is under
the engine base.
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Lanai 48 See Thru Installation Manual • 4113-901 Rev. D • 8/21
The supplied grommet can
•
Using the tabs, mount the wall control switch
assembly to a stud within 14' of the appliance.
Control
Mounting Box
Wall Switch
Wires
Figure 5.8. Wall Switch Mounting
17
Advertisement
Table of Contents
