Table of Contents
Advertisement
Ceiling or
Overhang
4 in.
(101 mm)
minimum - one side only.
Figure 3.4
Clearances to Combustibles
WARNING! Risk of Fire! Comply with all minimum
clearances to combustibles as specified. Framing
or finishing material closer than the minimums
listed must be constructed entirely of non-
combustible materials (i.e., steel studs, concrete
board, etc).
C. Hearth Extension/Floor Protection
This application does not require a hearth
extension.
D. Stand-Alone Installation
This appliance may be installed as a stand-
alone unit.
•
Construct a stand-alone framing of combustible
or noncombustible materials.
•
Cement board or other noncombustible
material can be applied directly to the face of
the appliance.
•
Tape and seal all joints and corners.
•
Provide
proper
management if installed on surfaces that may
rot or otherwise be damaged by water. (See
also Section 4.B.)
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Lanai 48 See Thru Installation Manual • 4113-901 Rev. D • 8/21
8 in.
(202 mm) min.
Non-combustible
39 in.
(990 mm)
min.
(1626 mm)
flashing
and
moisture
• Built-in Installation
When this appliance is installed into a wall, we
recommend that the wall be an exterior wall
system.
•
See framing measurements in Figure 3.2 and 3.4.
•
You must maintain 1
back and sides. See Figure 3.2
•
The header must not be placed below the top
of the top standoffs.
64 in.
•
Noncombustible wall sheathing material is
min.
required 8" above the appliance. (See Figure
3.4)
•
An 8" tall cement board has been provided for
this installation.
Flash the perimeter of the appliance, corners and
the appliance face in a manner consistent with
regional practices as required to prevent water
penetration around the appliance. See Section
3B and Figure 3.3 and 3.4 for more information
regarding wall and enclosure construction.
⁄
in. air space at the
1
2
11
Advertisement
Table of Contents
