Table of Contents
Advertisement
After the location of the mark line is determined, users need to confirm the
operation (soft keyboard "Enter" key or hard keyboard "OK" key).
Users also can click on the "mark to the peak" or "mark to the valley" to
determine the location of the mark line.
For M2~M5, the system also supports difference marker relative to M1. Users
click on the "MX-M1", the system will go into the difference marker mode. The
status displayed in the status bar is the difference between X and Y direction, i.e.
(MX2~5-MX1; MY2~5-MY1).
3.4.2
Limit Line
In all five measurement mode users can use limit line function. The user click on
the "limit"menu, the limit menu will appear on the right side of screen. The user
click on the "[On]/off" menu and activate this function. The limit line status
information will display on the top of the screen.
Limit menu
Figure 9.:
System supports single section and multi section limit line.
The user clicks on edit box of limit line status(x, y independently), the new edit
menu will pop-up on the left of the screen.
15
April 2016
Advertisement
Table of Contents
