Table of Contents
Advertisement
Detailed description:
Function
Status bar
Measurement
information
Function
menu 1
April 2016
Function and Description.
Power management mode: standard and power saving
mode.
Measurement state: idle and measuring.
Time: year/month/date/hour/minute.
The adapter and battery state:
1. Connect an external adapter, without battery -
display adapter icon;
2. Connect an external adapter, with battery charging
- display charging icon;
3. Connect an external adapter, with battery full -
display adapter icon;
4. Without adapter, only battery - display battery icon,
divided into 5 levels. If battery is low voltage
system will alarm.
Calibration state: (valid)On or (unvalid) off
Note: Only when calibration is valid (on), user can start
measurement.
Marker information.
Limit line information.
Measurement points: 137, 275, 551, 1103.
Start and stop frequency and distance.
Cal mode: enter calibration interface.
Parameter: enter parameter setting menu. If user in the
freq-return
loss/
mode, it will go into frequency parameter setting menu; If
user in the DTF-return loss/DTF-VSWR measurement
mode, it will go into DTF parameters menu, more
parameters and information will be included in this menu.
Display: For details see later chapter.
Data-> Mem: Save current data to memory.
Note: only one data can be save to the memory.
Auto Run: Start continuous measurement, clicks again to
stop.
Note: While measuring and Auto Run state is on, some
functions are prohibited. If users want to use these
function again, need to click the menu once again and
check the state is off.
Single run: Start single measurement, the system enters
the idle state after measurement.
freq-VSWR/cable
loss
measurement
12
Advertisement
Table of Contents
