Connecting To The Slave Cmm - ClearCube V7000 User Manual

9. Connecting to the Slave CMM

If you have installed two CMMs in one Blade System, one CMM should be assigned
as the master CMM and the other as the slave CMM. You should connect to the
master CMM for full-function management. However, you may also connect to the
slave CMM for event log checking, Logon Management and CMM settings.
After logging in, you see fewer UIs in the slave CMM, as shown in Figure 9-1. These
include only the Event Log, Logon Management and CMM Settings.
At the bottom is a yellow message bar showing that you are currently connected to the
slave (Redundant) CMM and telling you to connect to the master CMM. You may
refer to the master CMM IP address given to connect to the master CMM.
Figure 9-1. Connecting to Slave CMM
34