Menu Item Programming - Cleveland CR-28 Operator's Manual

Operator's Manual
M enu I t em Pr ogr am m i ng - Rot i s s er i e C ont r ol l er
1. Acces s M enu I t em Pr ogr am m i ng ( Pas s wor d 5- 1- 5- 10)
Password
PROG
____
Only persons
(In any
who know the
mode
password can
except
set or change
cook)
cooking
parameters
2. Sel ect M enu I t em Key t o Pr ogr am
Press The Menu Item's
any indicator light
Menu begins flashing
Item to show it is in
key the program mode
3. St ep T hr ough and Pr ogr am Des i r ed Par am et er s
Every time you press the Menu Item key, the next parameter is displayed.
You can stop at any parameter and make changes. Moving on to the next
parameter causes the value in the current parameter to be stored
S tage 1
hh:mm:ss
S tage 2
hh:mm:ss
S tage 3
hh:mm:ss
Hold
hh:mm:ss
4. Exi t Pr ogr am m i ng M ode
PROG
Press the
PROG key.
The controller
will return to
its previous
operation
15
Password
****
When you press the
password keys, the
2nd line of the display
shows star characters.
After the 4th key,
it checks the code.
NOTE: If during programming you don't
press any button for 5 minutes,
the controller will automatically
exit the programming mode
and return to its previous state
S tage 1 S tage 1
___ F
_ (vent) _
S tage 2 S tage 2 S tage 2
___ F
_ (vent) _ _ (vent) _
S tage 3 S tage 3
___ F
_ (vent) _
Hold Hold
___ F
_ (vent) _
If the password is correct,
the "Program Item" / "Version"
message is shown.
If the password is incorrect
the controller returns to
the mode it was in.
How t o Pr ogr am t he Par am et er s ?
First, use the Programmer's Worksheet in this guide to prepare
a program's desired values and settings. Then, follow
the instructions on the next page to program the parameters.
S tage 1 S tage 1
S peed _ ____ Heat
S tage 2 S tage 2
____ Heat
S peed _
S tage 3 S tage 3
S peed _ ____ Heat
Pressing the Menu Item
Hold
key after the last Hold
Fan _____
parameter causes the
display to return to Stage 1
Program
Item
Version
CR xx.xx
The "Program Item" / "Version Number"
message indicates that a
Menu Item key should be
pressed to begin programming.
NOTE:
The controller is pre-programmed
at the factory with default settings.
Some Menu Items have typical
cooking programs, and some have
no time programmed, making them
"Unused."A system Level password
can be used to revert all settings
to default.
Cleveland Range, Inc.