L2 Repair Document
Plastic Flake
Screwdriver
4.3 Disassembly process
The steps of disassembly one touch 930D are as below.
This module should only be disassembled from bottom to top.
Step 1: Remove the battery cover and battery.
Step 2: Take off the 7 screws from the furnished frame by screw driver
Step 3:
Separate the furnished frame from furnished front casing
the location of side key、LCD and
Rev.
1.0
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
By NCK Team
Tweezers
Soldering iron
touch lens FPC
one touch 930D Level 2 Repair Document
TCT
Mobile Limited
Hot wind gun
Camera Jig
by using plastic flake (NOTE:
as below picture shows)
Page
17/33