L2 Repair Document
Plastic Flake
Screwdriver
(TORX6)
4.3 Disassembly process
The steps of disassembly ONE TOUCH 4010 are as below.
This module should only be disassembled from bottom to top.
Step 1: Remove the battery cover and battery.
Step 2: Take off the 4 screws from the furnished frame by screw driver
Rev.
1.2
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
By NCK Team
Tweezers
Soldering iron
ONE TOUCH 4005D Level 2 Repair Document
TCT
Mobile Limited
Hot wind gun
Camera Jig
Page
14/29