Advertisement
L2 Repair Document
Plastic Flake
Screwdriver
(TORX6)
4.3 Disassembly process
The steps of disassembly one touch 992D are as below.
This module should only be disassembled from bottom to top.
Step 1: Remove the battery cover and battery.
Step2: Take off screws
1). Take off the 6 screws from the furnished frame by screw driver
2). Remove the furnished front deco according to below instruction by using plastic flake,
Rev.
1.0
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
By NCK Team
Tweezers
Soldering iron
one touch 992 Level 2 Repair Document
TCT
Mobile Limited
Hot wind gun
Camera Jig
Page
17/39
Advertisement
