Page 1
Note: this manual is non-contractual and TCT can modify it without prior notice on the characteristics of described equipments. Rev. Page one touch 902 Level 2 Repair Document 1/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 2
Draft creation Ting ting He Rev. Date Modification description Prepared By Checked By Approved By Rev. Page one touch 902 Level 2 Repair Document 2/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 3
Function test Disassembly L2 Repair PCBA Replace Retest Reassembly Retest Restore User Information Record in BIG Rev. Page one touch 902 Level 2 Repair Document 4/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 4
Corrosion on the USB connector, SIM connector, and other metal surfaces。 Hole (diameter > 1mm) Rev. Page one touch 902 Level 2 Repair Document 5/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 5
Enter the phone code if necessary. After the phone power on, test step by step with the auto test code: Rev. Page one touch 902 Level 2 Repair Document 6/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 6
Ⅱ. Press “Pass” to continue. CAMERA Test Ⅰ. Scene will be shown on the screen. Rev. Page one touch 902 Level 2 Repair Document 7/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 7
Ⅰ. The phone will running the BT and show the BT address on screen Ⅱ. Press "Pass" to continue Rev. Page one touch 902 Level 2 Repair Document 8/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 8
Camera Jig (TORX6) 4.3 Disassembly process The steps of disassembly one touch 902 are as below. This module should only be disassembled from bottom to top Step 1: Remove the battery cover and battery. Step2: Take off the 7 screws from the furnished frame by screw driver.
Page 9
Step 5:Remove furnished keypad FPC & LCD Module FPC connector, and extract the camera by camera jig. Rev. Page one touch 902 Level 2 Repair Document 13/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
Page 23
Finally put all the packing boxes into packing cases strong enough and post to HK. Rev. Page one touch 902 Level 2 Repair Document 27/28 All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.