Maintenance And Repairs; Disposal - Stihl FT 250 Instruction Manual

English
Engine power to ISO 8893: 1.6 kW (2.2 bhp) at
Idle speed:
Cut-off speed (rated):
Max. output shaft speed
(cutting attachment):
29.2 Ignition system
Electronic magneto ignition
Spark plug (resistor type): NGK BPMR 7 A,
Electrode gap:
29.3 Fuel System
All position diaphragm carburetor with integral
fuel pump
Fuel tank capacity:
29.4 Weight
dry, without cutting attachment and
limit stop:
29.5 Overall length
without cutting attachment
29.6 Exhaust Emissions
The CO value measured in the EU type approval
2
procedure is specified at www.stihl.com/co2.
The measured CO value was determined on a
2
representative engine in accordance with a
standardized test procedure under laboratory
conditions and does not represent either an
explicit or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission requirements
are fulfilled by the intended usage and mainte‐
nance described in this instruction manual. The
type approval expires if the engine is modified in
any way.

30 Maintenance and Repairs

Users of this machine may only carry out the
maintenance and service work described in this
user manual. All other repairs must be carried
out by a servicing dealer.
STIHL recommends that you have servicing and
repair work carried out exclusively by an author‐
ized STIHL servicing dealer. STIHL dealers are
regularly given the opportunity to attend training
courses and are supplied with the necessary
technical information.
32
9,000 rpm
2,800 rpm
10,500 rpm
9,270 rpm
Bosch WSR 6 F
0.5 mm
640 cc (0.64 l)
6.1 kg
1545 mm
30 Maintenance and Repairs
When repairing the machine, only use replace‐
ment parts which have been approved by STIHL
for this power tool or are technically identical.
Only use high-quality replacement parts in order
to avoid the risk of accidents and damage to the
machine.
STIHL recommends the use of original STIHL
replacement parts.
Original STIHL parts can be identified by the
STIHL part number, the { logo and the
STIHL parts symbol K (the symbol may appear
alone on small parts).

31 Disposal

Observe all country-specific waste disposal rules
and regulations.
STIHL products must not be thrown in the gar‐
bage can. Take the product, accessories and
packaging to an approved disposal site for envi‐
ronment-friendly recycling.
Contact your STIHL servicing dealer for the lat‐
est information on waste disposal.
0458-262-0121-C