MULTIQUIP Whiteman J36 Series Operation Manual page 28

4. Place the centrifugal safety "STOP" switch
(Figure 26) in the "ON" position.
OFF
ON
CENTRIFUGAL
SAFETY "STOP"
SWITCH
Figure 26. Centrifugal Safety"Stop"
Switch (ON)
CAUTION
NEVER disable or disconnect the centrifugal "STOP"
switch. It is provided for the operator's safety and injury
may result if it is disabled, disconnected or improperly
maintained.
5. If starting a cold engine place the choke lever (Figure 27 )
in the CLOSED position.
HONDA GX
CHOKE
LEVER
CLOSED
Figure 27. Choke Lever (Closed)
6. If starting a warm engine place the choke lever
(Figure 28) in the "OPEN " position.
PAGE 28 — J36/B46-M30 SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (10/27/16)
*Always follow manufacturer instructions*
ROBIN-SUBARU
CHOKE
LEVER
CLOSE CLOSED
OPEN
*AAA Rent-All 225-291-1356*
HONDA GX
CHOKE
LEVER
OPEN
Figure 28. Choke Lever (Open)
7. Grasp the starter grip (Figure 29) and slowly pull it out.
The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
Figure 29. Starter Grip
8. If the engine has started, slowly return the choke lever
(Figure 27), cold start only to the CLOSED position. If
the engine has not started repeat steps 1 through 6.
9. Before the trowel is placed into operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a loose guard ring
and/or covers.
Testing the Centrifugal Safety Stop Switch
1. With the engine running at idle, place the safety stop
switch lever in the "OFF" position (Figure 30). Verify
that the engine shuts off. If the engine continues to run,
replace centrifugal safety stop switch.
OPERATION
ROBIN-SUBARU
CHOKE
LEVER
CLOSE
OPEN
OPEN
STARTER
GRIP