MULTIQUIP Whiteman J36 Series Operation Manual page 23

4. Thread brass set nut #2 (Figure 11) towards the cable
as far as possible.
5. Insert the cable end through the yoke eyelet
(Figure 12). Tighten brass set nut #1 by hand to remove
all the slack from the cable.
BLADE
PITCH
CABLE
YOKE
YOKE
EYELET
BRASS SET
BRASS SET
NUT #1
Figure 12. Pitch Cable Yoke Attachment
6. Using a wrench, tighten the brass set #2 nut up against
the yoke boss. This will lock the cable in place.
J36/B46-M30 SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (10/27/16) — PAGE 23
*Always follow manufacturer instructions*
NUT #2
*AAA Rent-All 225-291-1356*
ASSEMBLY AND INSTALLATION
7. Use a wrench and finish tightening the brass set #1
nut up against the yoke boss.
Pre-Load Adjustment (Quick Pitch™ Handle Only)
WARNING
The Quick Pitch™ handle is spring loaded, personal
injury or damage could result from improper handling,
installation or adjustment. Use extreme caution when
installing this component.
1. After the Quick-Pitch™ handle has been installed on
the trowel, spring pre-load adjustment will be required.
2. Locate the spring pre-load adjustment screw (Figure 13)
on the underside of the handle tube.
PRELOAD TRIM INDICATOR
J
FINISH
Figure 13. Spring Pre-Load Adjustment
3. A decal has been placed on the side of the handle
tube to assist the user in the adjustment of the spring.
4. Depending on the type of blade and trowel being used,
align the groove on the slider with either the letter "J" or
"B" on the decal. The letter "J" stands for J-36 series.
walk-behind trowel, conversely the letter "B" stands for
B-46 series walk-behind trowel.
ALIGNMENT
DECAL
B
FINISH
COMBO COMBO
ADJUSTMENT
SCREW
SLIDER
GROOVE