Periodic Checks And Maintenance; Long Term Storage - Promate 7000D ES Silent Operator's Manual

Air-cooled diesel generator
Table of Contents

Advertisement

7-1.1 Changing engine oil
Remove the oil filler cap, remove the drain
plug and drain the used oil while the engine
is still warm. The plug is located on the
bottom of the cylinder block. Tighten the
drain plug and refill with the recommended
oil.
Place a collection tray below the oil drip nozzle
7-1.2 Cleaning the oil filter
Loosen the fixing bolt and then pull out the
oil filter
Change
7-1.3
Changing
the
element
Do not wash the air cleaner element with
detergent because this is a wet type
element.
Change
8
Oil filter cap
Drain plug
Oil filter
air
cleaner
Never run the engine without the
element or with a defective element.
7-1.4 Cleaning and replacing the
fuel filter
The fuel filter also must be cleaned
regularly to insure maximum engine
output.
Clean
Every 3 months or 100 hours
Replace
Every 6 months or 300 hours
7-1.5
Checking
the
nozzle injection pump etc.
This requires special tools and skills, so
contact your dealer.
7-1.6 Replacing piston ring
This requires special tools and skills, so
contact your dealer.

7-2 Long term storage

If your generator set should be stored
for
a
long
time,
preparation should be made:
(1) Operate the diesel engine about 3
minutes, and stop it
(2) Stop the engine. Drain the engine
lube oil while the engine is still
warm and fill with new oil
(3) Clean and store it in a dry place.
Element
injection
the
following
9
9

Advertisement

Table of Contents
loading

Table of Contents