Operating Your Generator Set; Operating Your Generator; Checks During Operation; Load - Promate 7000D ES Silent Operator's Manual

Air-cooled diesel generator
Table of Contents

Advertisement

Push down the decompression lever
(2)
(C) (It will return automatically after
the engine starts)
Install and secure the top cover
(3)
Start the generator as per 4-1
(4)
Electric starting
Never use any volatile liquid or gas such as
gasoline to cold starting the machine, or
else, severe damage will occur.
Operating Your
5.
Generator Set

5-1 Operating your generator

(1) Warm up the engine without load for 3
minutes.
(2) This generator is
equipped
oil warning system. The engine will stop
automatically in case of low oil pressure or
a lubrication oil shortage. The engine will
stop immediately without a lubrication oil
refill. Check the oil level and refill.
(3) Do not loosen or readjust either the engine
speed limiting bolt or fuel injection limiting
bolt [They had been already well adjusted
before
leaving
factory),
performance may be affected.

5-2 Checks during operation

(1) Any abnormal sound or vibration?
(2) The engine misfiring or running rough?
(3) What about the color of the exhaust gas?
(Is it black or too white?). If you notice any
situation mentioned above, please contact
your dealer.

5-3 Load

To add load according to specified parameter.
A.C application
(1) Set AC breaker to "ON". Pilot lamp will
(C)
illuminate, the speed of generator must
reach rated speed [lever at top).
(2) Insert the receptacle with the plugs of
electric instruments to be connected, keep
the switches of the connected electric
instruments to "OFF'.
The instruments which require much
starting current and some kinds of motors
may be unable to be use even if they are
within the applicable scope.
The circuit breaker turns "OFF' when the
current exceeding the applicable scope is
used or when the applied instrument is
defective.
The current of the instruments which
should not exceed the rated current
showed on the socket, or else it may
damage the machine.
DC application
(1) When the instruments connect with the DC
terminal, please make sure to the positive
polarity.
(2) DC output 12V 8.3A - 100W. 10
Stopping Your
6.
Generator Set
(1) Pull out the plug of an electric appliance
from the receptacle
with
low
(2) Set the AC breaker to "OFF'
(3) From lowest to highest load, run the engine
for about 3 minutes with no load.
(4) Return the engine speed lever to the
"STOP" position
(5) In electric-start models, return the starter
key to the "OFF" position
(6) Set the fuel chock lever to "S" (closed)
position.
otherwise
Slowly pull out the recoil handle until pressure
6
is felt (that is, to the point in the compression
stroke where the intake and exhaust valves are
closed), and leave the handle in this position
this prevents rust from forming while the
engine is not in use.
When stopping the engine, reduce the load slowly.
Do not stop the engine suddenly since it may cause
the temperature to rise abnormally.
7

Advertisement

Table of Contents
loading

Table of Contents