Table of Contents
Advertisement
Utility Stitches
c
Using a basting stitch, continue sewing to the edge of
the fabric.
a
b
d
Press open the seam allowance from the wrong side of
the fabric.
1
e
Align the seam with the center of the zipper, and then
baste the zipper in place to the seam allowance.
2
1
3
f
Remove about 5 cm (2 inches) from the end of the
basting on the outside.
2
4
3
1
g
Attach the presser foot holder to the right pin of zipper
foot "I".
1
I
2
h
Select a stitch.
No.
1-03
Stitch
• For details, refer to "Stitch Chart" on page 49.
64
1 Basting stitching
2 Wrong side of fabric
1 Wrong side of fabric
1 Wrong side of fabric
2 Basting stitching
3 Zipper
1 Wrong side of fabric
2 Zipper basting
3 Outside basting
4 5 cm (2 inches)
1 Pin on the right side
2 Needle drop point
CAUTION
• When using zipper foot "I", be sure to select
the straight stitch (middle (center) needle
position), and slowly turn the handwheel
toward you (counterclockwise) to check that
the needle does not touch the presser foot. If a
different stitch is selected or the needle hits
the presser foot, the needle may bend or
break.
i
Topstitch around the zipper.
1
3
2
4
1 Stitching
2 Right side of fabric
3 Basting stitching
4 End of zipper opening
CAUTION
• When sewing, be sure that the needle does not
touch the zipper, otherwise the needle may
bend or break.
Memo
• If the presser foot contacts the zipper slider, leave
the needle lowered (in the fabric) and raise the
presser foot. After moving the slider so it will not
contact the presser foot, lower the presser foot and
continue sewing.
j
Remove the basting stitching.
Advertisement
Table of Contents
