Subaru Outback 2011 Owner's Manual page 353

9-16
In case of emergency
outlets" F6-10.
10. Turn the ignition switch to the "Acc"
position.
WARNING
Running the engine in a non-venti-
lated or poorly ventilated area (e.g.,
inside a building) may cause as-
phyxiation. Do not start the engine.
1) Compressor switch
11. Press the compressor switch to "I".
CAUTION
. Before pressing the compressor
switch to "I", check the sidewall
of the tire prior to inflation. If
there are any cracks, bumps or
similar damage, do not attempt to
inflate the tire.
. Do not stand directly next to the
tire while the compressor is
pumping.
. Watch the sidewall of the tire
while the compressor is pump-
ing. If any cracks, bumps or
similar damage appear, turn off
the compressor and let the air
out by means of the pressure
relief valve. In this case, do not
continue to use the tire.
NOTE
When pumping in the sealant through
the tire valve, the pressure may rise up
2
to 600 kPa (6.1 kgf/cm , 87 psi), but it
will drop again after 30 seconds.
12. Inflate the tire for no longer than 10
minutes to an inflation pressure of a
minimum of 180 kPa (1.8 kgf/cm
psi) and a maximum of the pressure
specified for your vehicle.
NOTE
Turn off the compressor briefly in order
to read the actual tire pressure from the
pressure gauge.
WARNING
If the tire inflation pressure does not
reach 180 kPa (1.8 kgf/cm
within 10 minutes, the tire may have
suffered excessive damage, making
a temporary repair impossible. In
this case, do not continue to use the
2
, 26
2
, 26 psi)