Maintenance And Care; Troubleshooting - Clarity C4105 User Manual

Dialing an EMERGENCY Number
1. Press the TALK button.
2. Press the EMERGENCY key you wish to call.

MAINTENANCE AND CARE

The C4105 has been designed to give you years of dependable service with a
minimum of care. To ensure the utmost in performance, follow these guidelines
in caring for the unit:
1. Avoid dropping or knocking the unit.
2. Dust the unit regularly.Wipe the unit with a soft damp cloth.
3. Do not use detergents and avoid excess moisture.
4. The C4105 is an electrical device. Avoid electric shock by keeping the
phone away from water (i.e. bathroom, kitchen sink, etc.)

TROUBLESHOOTING

The unit will not operate/no dial tone:
Verify the TALK Button is lit.
•
Verify the AC Adapter is securely plugged into AC outlet and the base.
•
Verify the telephone line cord is securely plugged into the wall jack and
•
the telephone.
Make sure the base antenna is in an upright position.
•
Make sure the handset battery is fully charged.
•
Verify the telephone is in the correct dialing mode, tone (touch) or
•
pulse (rotary).
Make sure you are in the usable range of the base station.
•
Reset the security code by placing the handset in the base for 5-10 seconds.
•
The phone does not ring when you receive a call:
Make sure the RINGER switch on the handset and base are set to ON.
•
Verify the AC Adapter is securely plugged into AC outlet and the base.
•
Verify the telephone line cord is securely plugged into the wall jack and
•
the telephone.
Make sure you are in the usable range of the base station.
•
You may have too many phones on your line.Try unplugging a few devices.
•
20
Noise, Static, Interference or Other Calls Heard While Using
the Handset:
Try changing channels.
•
Make sure the base antenna is in an upright position.
•
Make sure you are in the usable range of the base station.
•
Make sure the handset battery is fully charged.
•
Try relocating the base unit to another location.
•
Make sure the AC Adapter is not plugged into the wall outlet with
•
other appliances.
Phone Will Not Hold Charge:
Make sure the charging contacts on the handset and base are free of dust and
•
dirt. Clean the contacts with a soft cloth.
Make sure CHARGE LED on the base is lit when handset is in the cradle.
•
If necessary, replace the handset battery. (See Handset Battery Charging)
•
Difficulty in Placing or Receiving Calls:
Move closer to the base and try again.
•
If moving closer does not work, you may have lost the security code.
•
Reset code by placing the handset back on the base for 5-10 seconds. (See
•
Security Code Section)
• Make sure you have selected the correct dialing mode, tone or pulse.
Make sure the AC Adapter is not plugged into a wall outlet with other appli-
•
ances. Disconnect for 5-10 seconds then reconnect. Place the handset back
on the base and reinsert the AC Adapter.
Make sure the handset battery is fully charged.
•
21